![]() ![]() Quickly return to the Hubble Connected for Motorola Monitors App.Please just continue and ignore this message.) (Below the CameraHD you may see ‘Unsecure Network’. Once the connection is successful, a blue checkmark on the left of “CameraHD” will appear. ![]() At the displayed list, there should have a network called “CameraHD”.Go to your phone’s Wi-Fi list by going to mobile device settings and pressing on “Wi-Fi”.When Bluetooth® is activated the app will automatically search for and connect to your camera.Return to the home screen, and open the “Hubble Connectedfor Motorola Monitors” app again to continue.Go to your Phone Settings and activate it. ![]() If Bluetooth® is not activated on your iPhone or iPad you are prompted to turn on Bluetooth® to allow the app to connect.Follow the new on-screen instructions and click on Continue.You will hear a beep (except if you’re setting up an outdoor camera), followed by a voice prompt indicating that the camera is ready for pairing. Press and hold the PAIR button for 3 seconds (Depending on the model the pair button is either located at the bottom of the camera OR on the side near the on/off button).Switch ON the camera and wait until the RED LED starts blinking. Make sure the camera is plugged into a power source.Select the camera model that you are using from the options that are shown. If you do not see your specific model listed, please select “Other Cameras” at the bottom of the page.Tap the +icon in the lower right corner of the screen.Plug in the camera, turn it on and place it within range of yout Wi-Fi router.If you have a set with a parent monitor, we recommend turning off your parent monitor while adding the camera to the app to avoid any interference. #Hubble app for motorola bluetooth password#Make sure you have the Wi-Fi® password at hand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |